Reply To: Gridlock when using A-B-C-B

Home Forums Support Gridlock when using A-B-C-B Reply To: Gridlock when using A-B-C-B

#12260
FX2K
Participant

i’m checking the site every 8 hours for the patch that allows us waypoints….

Most patches have been released on Fridays, if I remember correctly

 

I never experienced this Problem, did you use this layout? (Red arrows are one-way-signals)

Lines changing to different paths happens quite a lot for a variety of setups, especially if there are tracks crossing.

If I get time, I will mock up some examples of where this can happen, but here is a screenshot or three showing how two lines can merge to use a single track and then be forced back to how it was (sep tracks) by switching a signal from on to off and back on again… I have lots of examples where adding a signal can rectify the line, then bulldozing it leaves the line as intended.. until another change the other side of the map causes it to re-evaluate

http://www.train-fever.com/forums/topic/waypoints-desperately-needed/#post-11462

Platform selection / waypoints will prevent this.

 

  • This reply was modified 9 years, 7 months ago by FX2K.