Line Becomes Nullified When Trains are assigned to it

Home Forums General Discussion Line Becomes Nullified When Trains are assigned to it

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #18901
    recnilcram
    Participant

    So I had a 3 stop, double track line that had been working and profitable. I went to make one change at a stop by destroying one track switch to make it go the other way as to not use the same track at the station as another line. Once I did this, however, the track was voided. I took my three trains off of the line, and then the line reappeared, but whenever I try to reassign them or other electric trains (I haven’t tried with diesel) the line is voided again. Thoughts?

    #18909
    Pasi
    Participant

    Your electrification for the line is not complete. Line shows without electric trains as the track is there but when you assing electric trains, they can’t travel on it because there is a gap in the overhead line somewhere.

Viewing 2 posts - 1 through 2 (of 2 total)
  • The forum ‘General Discussion’ is closed to new topics and replies.