Performance-Probleme mit 4K (3840×2160) – Train Fever /forums/topic/performance-probleme-mit-4k-3840x2160/feed/ Wed, 30 Apr 2025 12:41:59 +0000 https://bbpress.org/?v=2.6.13 en-US /forums/topic/performance-probleme-mit-4k-3840x2160/#post-15576 <![CDATA[Performance-Probleme mit 4K (3840×2160)]]> /forums/topic/performance-probleme-mit-4k-3840x2160/#post-15576 Sat, 03 Jan 2015 22:30:03 +0000 Iceman05 Hallo,

ich bin nun schon im Jahr 2079 bei Train Fever und so langsam wird das Spiel unspielbar, da es sehr oft ruckelt und ich nur noch mit 7-10 FPS spielen kann. Verringere ich die Auflösung auf 1920×1080 läuft es wesentlich besser, allerdings sieht dann alles verschwommen und verpixelt aus. Deshalb kommt diese Auflösung für mich nicht in Frage.

Mein System:

i7-4790k
16GB Ram
250GB SSD
GTX 970 4 GB / R9 290X 8GB
Windows 8.1 und selbstverständlich alle Treiber auf aktuellem Stand

Während die GTX 970 eingebaut war, konnte ich sehen, dass die vollen 4 GB Speicher belegt waren, was mich auf die Idee gebracht hat, eine Grafikkarte mit 8 GB könnte das Problem lösen. Nachdem ich nun die R9 290X mit 8 GB eingebaut habe, musste ich feststellen, dass laut Anzeige Train Fever nur ca. 2,3 GB des Speichers nutzt. Wie kann das sein? Sind beide Grafikkarten “zu langsam” für Train Fever oder stößt das Spiel an seine Grenzen?

 

GTX 970

 

R9 290X

]]>
/forums/topic/performance-probleme-mit-4k-3840x2160/#post-15583 <![CDATA[Reply To: Performance-Probleme mit 4K (3840×2160)]]> /forums/topic/performance-probleme-mit-4k-3840x2160/#post-15583 Sun, 04 Jan 2015 02:44:09 +0000 Mike I don’t understand anything from your German but I think the bad performance comes from CPU and not graphics card.
Did you tried to lower the resolution to see if it changes things?

]]>
/forums/topic/performance-probleme-mit-4k-3840x2160/#post-15587 <![CDATA[Reply To: Performance-Probleme mit 4K (3840×2160)]]> /forums/topic/performance-probleme-mit-4k-3840x2160/#post-15587 Sun, 04 Jan 2015 07:58:00 +0000 Blokker_1999 While I know just enough german to understand your posting, I don’t know enough to reply in it so I’m writing this in english.

The game is known to have performance issues. We have an entire thread on it on these forums : /forums/topic/req-multithreading-performance-issu-large-map/ . Unfortunatly the thread is placed in the wrong category (General discussion instead of support). To put it simple: the game engine has a design probblem where it only creates 2 threads. 1 for the foreground processing and 1 for the background stuff. When your game has advanced enough and you have a lot of tracks, roads and vehicles the second thread can’t calculate fast enough and can’t supply the first one with enough data.

If you would like to know more about the technical side you can read this german topic on another site: http://www.train-fever.net/index.php/Thread/2135-Was-macht-TF-Intern-und-warum-es-ruckelt/ . We are hoping someone from the developers will respond to these problems and we hope that this issue will be fixed in the near future.

]]>
/forums/topic/performance-probleme-mit-4k-3840x2160/#post-15594 <![CDATA[Reply To: Performance-Probleme mit 4K (3840×2160)]]> /forums/topic/performance-probleme-mit-4k-3840x2160/#post-15594 Sun, 04 Jan 2015 11:24:50 +0000 Iceman05 @clk_mike
I don’t think the bad performance comes from CPU. On my screenshot you can see the CPU utilization is 18 %.
A lower resolution (1920×1080) solved the problem, but this resolution isn’t nice on a 4K-Screen.


@Blokker_1999

Thanks for your informations. This problemes i have also since the mid of 21th century. So i understand that the only way to solve the problem is to wait for an update. 🙁

]]>
/forums/topic/performance-probleme-mit-4k-3840x2160/#post-15626 <![CDATA[Reply To: Performance-Probleme mit 4K (3840×2160)]]> /forums/topic/performance-probleme-mit-4k-3840x2160/#post-15626 Sun, 04 Jan 2015 21:21:34 +0000 Iceman05 I have to correct my statement. Even with a lower resolution the game run not good.

]]>
/forums/topic/performance-probleme-mit-4k-3840x2160/#post-15637 <![CDATA[Reply To: Performance-Probleme mit 4K (3840×2160)]]> /forums/topic/performance-probleme-mit-4k-3840x2160/#post-15637 Mon, 05 Jan 2015 00:53:48 +0000 FX2K Performance is bad, they know it is too although they consider it to be working as expected (their words not mine)… they have also said they are going to be improving this more over time..

I created similar threads on the performance in the past too:

Performance Issues – Decent Spec Rig.

Are we likely to see any additional performance improvements?

Below is a reply from Basil I received after sending a test file with a number of test scenarios to compare performance, around the time of the second thread above.

—– quoted from email received in November——-

Thanks very much for the detailed measurements and explanations.

I’ve re-done the measurements here with an Intel i7-3770 CPU with NVIDIA GeForce GTX 660 graphics card. My system should be slightly slower than yours.

I set the same graphics settings as you and played with 1920×1200 resolution.

Results are very similar to yours. My Fps (for your measurements 1-15) are proportional to yours. Most of them are simply 10% less than yours. So the behavior is as expected (however note that your system may be faster without Afterburner or Fraps running of course).

This said, let me briefly explain the situation.

You are right, the game could/should run faster, especially with multiple windows open (PIP).

We are working on this. You can expect improvements in the near future (however not in the next days / weeks). Here is our near-future-todo-list:

– Make PIP rendering less expensive
– Display PIP windows more intelligent (e.g. do not show 10 windows when buying 10 buses, as you suggest)
– Reduce CPU load (i.e. compute paths of all people / cars / agents not on the main thread / core. Use at least on more core for that. At the moment every time a person leaves a building, the shortest path to the destination is computed, and this is very expensive when having 10’000 persons)
– Make “end of month” CPU calculations faster / less blocking

Until then we can just suggest to not have multiple PIP windows open and to play small or medium maps if you are very “fps-sensitive”.

Thanks again for your efforts and best wishes,
Basil
——————————-

Until then though, the game is on my digital shelf.

]]>
/forums/topic/performance-probleme-mit-4k-3840x2160/#post-15642 <![CDATA[Reply To: Performance-Probleme mit 4K (3840×2160)]]> /forums/topic/performance-probleme-mit-4k-3840x2160/#post-15642 Mon, 05 Jan 2015 04:49:32 +0000 Blokker_1999 Thing is, they already did a part of that. The use of a second core is already implemented (as can be seen in the thread linked to me above on train-fever.net ). So unless they come up with a way to make that completly multithreaded (instead of just one extra thread) we will keep seeing performance issues (and those issues will remain for people with a dual core setup).

]]>
/forums/topic/performance-probleme-mit-4k-3840x2160/#post-15655 <![CDATA[Reply To: Performance-Probleme mit 4K (3840×2160)]]> /forums/topic/performance-probleme-mit-4k-3840x2160/#post-15655 Mon, 05 Jan 2015 12:48:23 +0000 FX2K The use of a second core is already implemented or appears to be yes, but how they are using it is unclear. My second linked thread shows it being used across 2 cores (4 due to HT) but that reply was received after I made that post, so I assumed they meant to further optimise how its using both.

Also, the other changes will make a huge difference during gameplay where the FPS drops drastically when doing something like buying 10 new vehicles.

I guess we will have to wait and see what they do or don’t have up their sleeves.
I also suggested something like:

Add a new settings option for Civ Simulation Level.
High: Civ’s 10,000. Scale of Ticket Prices – 100% (as it is now)
Medium: Civ’s 5,000. Scale of Ticket Prices – 200%
Low: Civs 2,500. Scale of Ticket Prices – 400%

to reduce the load from this particular area, fudging the numbers if you like (SC style)
The reply was:

———
Thanks for sharing the idea. I understand..

However, I think this is more a “emergency solution” which we only make if it’s really impossible to optimize.

We are very confident that we can optimize it so that this switch is not needed.

Best,
Basil
———

]]>